User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Default values of IN/OUT patches
In the default state of the DM3 series, the following input ports (connectors, ports, buses) are patched to the
respective input system channels.
Input System Channels Input Ports (Connectors, Ports, Buses)
CH 1-16 INPUT 1-16
ST IN L/R PLAYBACK L/R
FX RTN 1-2 L/R FX 1-2 L/R
In the default state of the DM3 series, the output ports (connectors, ports) are patched to the following
output channels. DANTE can only be used with DM3.
Output Ports (Connectors, Ports) Channel
OMNI OUT 1-6 MIX 1-6
OMNI OUT 7-8 STEREO L/R
DANTE 1-6 MIX 1-6
DANTE 7-8 STEREO L/R
DANTE 9-10 MATRIX 1-2
DANTE 11-12 MONITOR L/R
DANTE 13-16 NONE
USB 1-16 INPUT 1-16
USB 17-18 STEREO L/R
RECORDER INPUT L/R STEREO L/R
341
Appendix > Parameters