User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MIDI Data Format
This explains the formats that the DM3 series can interpret, send and receive.
Control change (Bn)
It can transmit arbitrarily assigned parameter.
<<Receive>>
Received when Control Change Rx is ON and Rx Ch matches, and controls parameters according to the
settings of the Control Change Event.
<<Send>>
Sent on the channel of Tx Ch when parameters configured with the Control Change Event are operated and
Control Change Tx is ON.
Control Change No. 0 and 32 are used for Bank Select in Program Change, so parameters cannot be assigned
to them.
STATUS 1011nnnn Bn Control change
DATA 00 Control number (00)
0vvvvvvv vv Bank Select MSB
STATUS 1011nnnn Bn Control change
DATA 20 Control number (32)
0vvvvvvv vv Bank Select LSB
STATUS 1011nnnn Bn Control change
DATA 0nnnnnnn nn Control number (1-31, 33-95, 102-119) *
0vvvvvvv vv Control value (0-127)
*96 to 101 cannot be used.
Conversion from Control value to parameter data:
(
If assigned parameters are CH ON:
<<Receive>>
0-63: Off, 64-127: On
<<Send>>
Off: 0, On: 127
(
If an assigned parameter is Fader H or Fader L:
358
Appendix > Materials