User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MONITOR (OSCILLATOR) screen
The MONITOR (OSCILLATOR) screen allows you to check the oscillator settings and turn it ON/OFF. The DM3
series has a built-in oscillator, which can be used to output signals like sine waves or pink noise to any
channel for checking external devices and testing the characteristics of the venue.
e f
b c
d
a
a
Oscillator mode button
For selecting from the following 3 oscillators.
(
SINE WAVE :
Outputs a continuous sine wave.
(
PINK NOISE :
Outputs pink noise continuously.
(
BURST NOISE :
Outputs pink noise in bursts.
b
Parameter field
Available parameters are displayed according to the oscillator mode.
When the oscillator mode is set to SINE WAVE, this sets the oscillator frequency.
When the oscillator mode is BURST NOISE, this sets the Width (length of noise) and the Interval (time between
noises).
When the oscillator mode is PINK NOISE, nothing is displayed.
74
Screen functions and names > MONITOR screen