User Manual

ManualsBrandsYamaha ManualsMixing consolesdigital console

Device features

Owner’s Manual

Tio1608-D2

• Switches 3, 7 and 8 (Tio1608-D compatibility

mode)

This mode is used to connect to older models that are

not compatible with the Tio1608-D2.

In the compatibility mode, the sampling frequency is

set to the maximum 48 kHz and external devices

recognize Tio1608-D2 as Tio1608-D.

- Activating the Tio1608-D compatibility mode

Configure the dip switches as shown above for

"Tio1608-D compatibility mode" and then switch the

power ON. When the red indicators on the front panel

stop flashing and only the green indicators are

flashing, that indicates the compatibility mode has

been successfully activated. Then switch the power

OFF, reconfigure the dip switch settings appropriately,

and switch the power back ON before using the

system. The green [SYSTEM] indicators will flash for

about 20 seconds only after switching to the Tio1608-

D compatibility mode.

- Canceling the Tio1608-D compatibility mode

Configure the dip switches as shown above for

"Cancels the Tio1608-D compatibility mode" and then

switch the power ON. When the red indicators on the

front panel stop flashing and only the green indicators

are flashing, that indicates the compatibility mode has

been successfully canceled. Then switch the power

OFF, reconfigure the dip switch settings appropriately,

and switch the power back ON before using the

system.

• Switch 4 (Dante SECONDARY port mode)

This switch determines the operating mode of the

Dante [SECONDARY].

When Quick Config is used, these switches are

disabled.

• Switches 5 and 6 (IP address mode)

These switches determine how the unit's IP address is

set.

• Switches 7 and 8 (start up mode)

These switches determine how the unit starts up

during start up mode. When set to "refresh" mode, the

settings of the mixer are applied when the unit starts

up. When set to "resume" mode, the unit returns to

the same state as the last time it was used.

When Quick Config is used, the "normal operation"

mode settings are disabled.

NOTE

If switches 7 and 8 are set to the "update mode" or

"diagnostic mode" positions, the unit will not be reset.

Switch

position

Operating mode

Tio1608-D compatibility mode

Cancels the Tio1608-D compatibility mode

(initialize mode)

Switch

position

[SECONDARY] operating mode

Daisy chain connection

Redu ndant connection

NOTE

When the Switch 4 is set to "Redundant connection", the

head amp control function (page 15) is only available via

the Dante [PRIMARY].

378

Switch

position

IP address mode

Auto IP (link local)

DHCP

Static IP Auto (192.168.0.ID)

Static IP Manual

The IP address is specified from an

external device such as R Remote V3.

Switch

position

Start up mode

REFRESH mode (normal operation)

RESUME mode (normal operation)

Update mode

Diagnostic mode

NOTE

• Update mode and diagnostic mode are used when

performing maintenance on the unit. Normally you will not

use these modes.

• Update mode and diagnostic mode can be enabled even

when using Quick Config. Normally you will not use these

modes.

5 6

7 8