User Manual

16
Input Channel
Output Channel
Surround Surround
L,R,C,LFE,Ls,Rs ON

Mode Stereo, 5.1

PAN

3.1,6.1

Divergence

LFE Level

<Key to table>  : converted ! : Check optimising logic below  : not converted
*Notes
1) Only the first four characters of the channel name are reproduced.
2) The HA setting of the PM5D internal INPUT connector is converted to the HA setting of the
Rio3224-D/Rio1608-D that is controlled by the CL/QL. In addition, the HA setting of the PM5D
internal ST IN connector is converted to the HA setting of the CL/QL internal OMNI IN connector.
3) The CL/QL has a Digital Gain setting in addition to the Attenuator setting. If the PM5D Attenuator
is set to 0 dB or higher, it is converted to a Digital Gain on the CL/QL. Furthermore, in the case of
conversion from CL/QL to PM5D, the sum of the CL/QL Attenuator and Digital Gain settings are
converted to the PM5D attenuator setting. When option 4 is ticked, the PM5D Attenuator settings
are converted to CL/QL Digital Gain settings in place of CL/QL Attenuator settings, even when the
PM5D Attenuator is less than 0 dB.
4) The input channel's Dynamics parameter is reproduced only when both the PM5D and CL/QL
configurations match. For example, in the case of conversion from PM5D to CL/QL, the PM5D
Gate and Compressor module settings are always converted to the CL/QL Dynamics1 and
Dynamics2 parameters. In the case of conversion from CL/QL to PM5D, the CL/QL Dynamics1
parameter is converted to the PM5D Gate module only when the Dynamic Type is Gate or
Ducking. The CL/QL Dynamics2 parameter is converted to the PM5D Compressor module only
when the Dynamic Type is Compressor or Compander. If these conditions are not applicable, the
Dynamics parameters are set to the default settings.
PM5D: Gate, CL/QL: Dynamics1
PM5D
Gate
Ducking
Off
CL/QL
Gate
Ducking
Other types
PM5D: Comp, CL/QL: Dynamics2
<Key to table> Blue field and arrow means compatible setting
Orange field and arrow means setting replaced by substitution
5) Pan/Balance parameters are reproduced only when the PM5D and CL/QL configurations are
matched. Due to the design differences in Pan and Balance, some parameters cannot be
completely reproduced. In such cases, the converter converts the parameters by making
appropriate adjustments to the settings on the basis of the rule that assumes audio on odd
channels are mapped to the left channel and audio on the even channels are mapped to the right
channel.
Input to Stereo & Input to Mix: Pan/Balance -Input Channel 1-48
PM5D
Individual/Gang/Inv.Gang mode
Balance mode
Pan for odd Ch
Pan for even Ch
Balance for odd & even Ch
CL/QL
Pan: Copy
Pan: Copy
Pan: L63
Pan: R63
Pan mode (only available mode)
PM5D
Individual mode
Pan: Copy
Pan: Copy
CL/QL
Pan for odd Ch
Pan for even Ch
Pan mode
Input to Stereo & Input to Mix: Pan/Balance -ST IN/Fx RTN
PM5D
Individual/Gang/Inv.Gang mode
Balance mode
Pan for odd Ch
Pan for even Ch
Balance for odd & even Ch
CL/QL
Pan: Copy
Pan: Copy
Balance: Copy
Pan mode
Balance mode
PM5D
Compressor
Compander
Off
CL/QL
Compressor
Compander
Other types