User Manual

Sending the signal from an input channel to a MIX bus
65
M7CL Owner’s Manual
Input channel operations
5
4
Use the faders of the top panel INPUT sec-
tion or ST IN section to adjust the send
level from the input channels to the
selected MIX bus.
5
Repeat steps 3–4 to adjust the send level
for other MIX buses in the same way.
6
When you’re finished adjusting the MIX
send levels, press the “×” symbol in the
function access area.
The function access area display will return to its prior
state, and the M7CL will exit SENDS ON FADER
mode and return to normal mode.
•You can assign the SENDS ON FADER function to a user-
defined key. This lets you quickly switch to SENDS ON
FADER mode for a specific MIX bus, and quickly switch back
again.
HINT