User Manual

M7CL V3 Editor Owner’s Manual
38
❏ INSERT (except for ST IN channels)
A ON
Enables/disables insert-in/out.
B OUT (Insert out)
Click this to select the output port that will be assigned to insert-out, from the following choices.
C IN (Insert in)
Click this to select the input port that will be assigned to insert-in, from the following choices.
D POINT (Insert point)
Selects the position at which insert-in/out will be patched. Choose from PRE EQ, PRE FADER, or POST ON.
E HA gain (M7CL-48ES)
Adjusts the HA gain for OMNI IN. This knob appears only if you select OMNI as INSERT IN (3).
F 48V (M7CL-48ES)
Switches phantom power (+48V) on/off. This button appears only if you select OMNI as INSERT IN (3).
❏ DIRECT OUT (except for ST IN channels)
A ON
Tur ns the direct output on/off.
B DIRECT OUT GAIN
Adjusts the gain of the direct output. The current value is shown in the numerical box below the knob. You can set
this to the nominal value (0.0 dB) by holding down the <Ctrl>(< >) key and clicking the knob.
NONE No assignment
OMNI 1-OMNI 8(M7CL-48ES) OMNI OUT jacks 1–8
SLOT1-1, SLOT1-2...SLOT3-15, SLOT3-16 Output channels of an I/O card installed in slots 1–3
RACK1A, RACK1B...RACK8R(B) L/R outputs of Rack 1–8
NONE No assignment
OMNI 1-OMNI 8(M7CL-48ES) OMNI IN jacks 1–8
SLOT1-1, SLOT1-2...SLOT3-15, SLOT3-16 Input channels of an I/O card installed in slots 1–3
RACK1A, RACK1B...RACK8R(B) L/R inputs of Rack 1–8
1
2 3
4
5
6
1
2 3 4