User Manual
Table Of Contents
Step 3 Bidirectional Loop Settings
13
End Loop settings
For our example we need a bidirectional loop to span the entire network. The start of the loop is by
default the Primary Master device. Assuming that the network was in mono directional mode, we
simply need to set the End Loop parameter on at the last device, DME8o-ES.
① Select DME8o-ES in Tree view.
② To turn the End Loop settings off, right click DME8o-ES in Tree view and move the mouse to
highlight “Device functions” as shown below.
A check mark appearing to the left of “End of BiDir Loop”, indicates that the “End of BiDir Loop”
parameter is on.
Devices which are part of a bidirectional loop will be indicated with green icons in Tree view as shown
below.