User Manual

Controls and Functions

MG12XUK Owner’s Manual

Top panel

Master section (Output: !5 to @3)

!5 [FX SEND] jack

For connecting an external effects unit or a monitor sys-

tem for players. This phone-plug jack outputs the sound

adjusted with the [FX] knob respectively.

!6 [STEREO OUT] jacks

For connecting a powered speaker or amplifier. These

jacks support both XLR and phone plugs.

!7 [PHONES] output jack

For connecting a set of headphones. This jack supports

a stereo phone plug.

!8 [MONITOR OUT] jacks

For connecting a monitor system for operators. These

jacks support phone plugs.

!9 [POWER] LED

Lights when the [ / ] switch on the rear panel is set

to on (pressed to the [ ] position).

@0 Level meter

The L and R meters show the level (volume) of the sig-

nal output from the [STEREO OUT] jacks by seven

steps; “PEAK” (+17), “+10”, “+6”, “0”, “-6”, “-10”, and “-20”

dB. If the “PEAK” lamp continuously lights in red, turn

the [STEREO LEVEL] knob to the left to lower the vol-

ume.

@1 [STEREO MUTE] switch

Turning the switch on ( ) will mute the sound of ste-

reo bus from the output of [MONITOR OUT] jacks or

[PHONES] jack. In this state, when setting the [TO

MON /TO ST ] switch !2 for channels 11/12 to

[TO MON ], you can hear the sound only from chan-

nels 11/12. For details about the switch, see the “Rear

panel USB section” on page 16.

@2 [MONITOR/PHONES] knob

Adjusts the volume output to the [MONITOR OUT] jacks

and the [PHONES] jack.

@3 [STEREO LEVEL] knob

Adjusts the overall volume output from the [STEREO

OUT] jacks.