User Manual

Technical Specifications
MG10XUF Owner’s Manual
22
Analog Input Characteristics
0 dBu = 0.775 Vrms
*1 Sensitivity is the lowest level that will produce an output of +4dBu (1.228V) or the nominal output level when the unit is set to maximum
gain. (All level controls are maximum position.)
*2 1&Sleeve = GND, 2&Tip = HOT, 3&Ring = COLD
*3 Tip = Signal, Sleeve = GND
Analog Output Characteristics
0 dBu = 0.775 Vrms
*1 1 = Ground, 2 = Hot, 3 = Cold
*2 Tip = Hot, Ring = Cold, Sleeve = Ground
Digital Input / Output Characteristics
*1 Data length is depend on the using audio format. USB Audio Class2.0: 16 / 24-bit, Yamaha Steinberg USB Driver: 24-bit
Input
Terminals
PAD
26 dB
GAIN Trim
Position
Actual Load
Impedance
For Use with
Nominal
Input Level
Connector
Sensitivity
*1
Nominal Max. before clip
MIC/LINE
1 - 4
OFF
+64 dB
3kΩ
50–600Ω
Mics/Lines
-80 dBu
(0.077 mV)
-60 dBu
(0.775 mV)
-40 dBu
(7.75 mV)
Combo jack
*2
(Balanced)
+20 dB
-36 dBu
(12. 3 mV)
-16 dBu
(122.8 mV)
+4 dBu
(1.228 V)
ON
+38 dB
-54 dBu
(1.55 mV)
-34 dBu
(15.46 mV)
-14 dBu
(154.6 mV)
-6 dB
-10 dBu
(245 mV)
+10 dBu
(2.451 V)
+30 dBu
(24.51 V)
LINE
5/6, 7/8
— — 10kΩ 600Ω Lines
-30 dBu
(24.5 mV)
-10 dBu
(245 mV)
+10 dBu
(2.451 V)
Phone jack
*3
RCA pin
(Unbalanced)
LINE
9/10
Phone jack
*3
(Unbalanced)
Output Terminals
Actual Source
Impedance
For Use with
Nominal
Output Level
Connector
Nominal Max. before clip
STEREO OUT [L, R] 75Ω 600Ω Lines +4 dBu (1.228 V) +24 dBu (12.28 V)
XLR-3-32
*1
Phone jack
*2
(Balanced)
MONITOR OUT [L, R]
FX SEND
150Ω 10kΩ Lines +4 dBu (1.228 V) +20 dBu (7.750 V)
Phone jack
*2
(Impedance Balanced)
PHONES 110Ω 40Ω Phones 3 mW + 3 mW 100 mW + 100 mW Stereo phone jack
Terminals Format Data Length
*1
Fs Connector
USB USB Audio Class 2.0 16 /24 bit
44.1 kHz, 48 kHz, 88.2 kHz,
96 kHz, 176.4 kHz, 192 kHz
USB Standard-B