User Manual

MG10XUF Owner’s Manual
13
Controls and Functions
o [PAN] knobs (channels 1 to 4)
[BAL] knobs (channels 5/6 and 7/8)
[PAN/BAL] knobs (channels 9/10)
[PAN]: Adjusts the volume balance of each channel
sent to the stereo bus, and determines the positioning of
the sound image between left and right (stereo L/R).
When the knob is located at the 12 o’clock position, the
channel’s sound will be sent to the stereo bus channels
(L and R) at the same volume. In this case, the sound
image is positioned at the center.
[BAL]: Determines the volume balance of the stereo
channels (5/6 to 7/8) (L/R) sent to the stereo bus. When
the knob is located at the 12 o’clock position, the sound
of the stereo channels will be sent to the stereo bus
channels (L and R) at the same volume respectively.
[PAN/BAL]: Provides both [PAN] and [BAL] functions.
You can use this as a [PAN] control when sound is input
to the [LINE] (L/MONO) jack, and as a [BAL] control
when sound is input to both [LINE] (L) and [LINE] (R)
jacks.
!0 [ON] switch
Turn this switch on ( ) to send the respective chan-
nel’s signal to the buses. The switch lights when on.
When this switch is off ( ), the respective signal input
is not sent to the FX bus.
NOTE
• Even if the [ON] switch is off, the PFL signal from each
channel can still be monitored via the [PHONES] jack.
• To minimize noise, turn the [ON] switch off for any unused
channels.
!1 [PEAK]LED
Lights when the volume of input and/or post-equalizer
sound is too high (when reaching 3 dB below clipping).
If it is lit frequently, turn the [GAIN] knob r to the left to
lower the volume.
!2 Channel faders
For adjusting the volume balance among the channels.
Generally, set this to the “0” position.
!3 [PFL] (Pre-fader Listen) switch
When the [PFL] switch is on ( ), the channel pre-
fader signal is output to the [MONITOR OUT] and
[PHONES] jacks for monitoring.
!4 [TO MON /TO ST ]switch
For selecting the output destination of the input sound
to channels 9/10. Normally set this switch to [TO
ST ]. When you use the unit with a computer con-
nected to the [USB 2.0] terminal, toggle this switch
according to your specific application, referring to the
chart in “Rear panel USB section.”
!5 [LINE] stereo input jacks (channels 5/6 to 9/10)
For connecting line-level devices such as an electric
keyboard or an audio device. These jacks support
phone plugs and RCA-pin plugs.
NOTE
Regarding input to channels 5/6 and 7/8, if both phone and
RCA-pin jacks are used at the same time, the phone jack will
take priority.
!6 [LINE /USB ] switch
Toggles the sound source input to channels 9/10. When
the switch is set to [LINE ], the source will be the
[LINE] stereo input jack !5, and when set to [USB ],
the source will be the [USB 2.0] terminal.