User Manual

MG10XUF Owner’s Manual
21
Technical Specifications
General Specifications
0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150Ω
All level controls are nominal if not specified.
*1 Noise is measured with A-weighting filter.
*2 Crosstalk is measured with 1 kHz band pass filter.
Frequency Response Input to STEREO OUT
+0.5 dB/-1.5 dB (20 Hz to 48 kHz) ,
refer to the nominal output level @ 1 kHz, GAIN knob: Min
Total harmonic distortion
(THD+N)
Input to STEREO OUT
0.03 % @ +14dBu (20 Hz to 20kHz), GAIN knob: Min
0.005 % @ +24dBu (1kHz), GAIN knob: Min
Hum & Noise
*1
(20 Hz to 20 kHz)
Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150Ω, GAIN knob: Max)
Residual Output Noise -102 dBu (STEREO OUT, STEREO master fader: Min)
Crosstalk (1 kHz)
*2
-83 dB
Input channels 10 channels: Mono [MIC/LINE]: 4, Stereo [LINE]: 3
Output channels STEREO OUT: 2, PHONES: 1, MONITOR OUT: 1, FX SEND: 1
Bus STEREO: 1, FX: 1
Input Channel Function
PAD CH 1 – CH 4 26 dB
HPF CH 1 – CH 4 80 Hz, 12 dB/oct
COMP CH 1, CH 2
1-knob compressor (Gain/Threshold/Ratio)
Threshold: +22 dBu to -8 dBu
Ratio:1:1 to 4:1,
Output level: 0 dB to 7 dB
Attack time: approx. 25 msec
Release time: approx. 300 msec
EQ
CH 1 – CH 4
HIGH: Gain: +15 dB/-15 dB, Frequency: 10 kHz shelving
MID: Gain: +15 dB/-15 dB, Frequency: 2.5 kHz peaking
LOW: Gain: +15 dB/-15 dB, Frequency: 100 Hz shelving
CH 5/6 –
CH 9/10
HIGH: Gain: +15 dB/-15 dB, Frequency: 10 kHz shelving
LOW: Gain: +15 dB/-15 dB, Frequency: 100 Hz shelving
PEAK LED CH 1 – CH 4
LED turns on when post EQ signal reaches 3 dB below of the
clipping level.
Level Meter Pre Monitor LEVEL 2x7 -segment LED meter [PEAK, +10, +6, 0, -6, -10, -20 dB]
Built-in Effect SPX Algorithm 24programs, PARAMETER control:1, FOOT SW:1 (FX RTN CH on/off)
USB Audio 2 IN / 2 OUT
USB Audio Class 2.0 compliant
Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit
Phantom Power Voltage +48 V
Power Requirements
PA-10 (AC 38 VCT, 0.62A, Cable length = 3.6 m)
or equivalent recommended by Yamaha
Power Supply adaptor 22.9 W
Dimensions (W×H×D) 275 mm × 110 mm × 390 mm (10.8” × 4.3” × 15.4”)
Net Weight 3.3 kg (7.3 lbs)
Included Accessory Owner’s Manual, AC Adaptor, Cubase AI Download Information
Optional Accessory Foot Switch: FC5
Operating Temperature 0 to +40°C