User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-13-
v4.0.6
n Dante Controller can now connect to Dante Domain Manager, enabling you to control enrolled
devices
n Support for legacy devices in domains
n Support for audio routing between domains
n Improved device status information for DDMnetworks
n Additional version information provided in the Device Info tab and the Device View > Status tab
v3.10.2
DanteController can now be updated directly from the user interface.
v3.10
n Device lock: Supported Dante devices can now be PIN-locked and unlocked usingDante Controller.
Locked devices cannot be controlled or configured.
n Advanced filter: Expands Dante Controller's device filtering functionality to include parameters such
as sample rate, latency and lock state.
n Wi-Fi interface support: Dante Controller can now connect to (and control) Dante networks via Wi-Fi.
Requires a Wi-Fi access point to be physically connected to the Dante network.
v3.6.2
n Support for AES67-enabled devices.
o
The Clock Status View now includes an AES67 Status column
o
The Create Multicast Flow panel now allows the creation of AES67 multicast flows
o
There is a new AES67 Config tab for AES67-enabled devices
o
The Device View > Receive Tab now includes AES67 multicast transmit flow channels (shown
in blue)
o
The Network View > Routing Tab now includes AES67 transmit channels (shown in blue)
n Support for Avid DNT-192 expansion cards.
Minimum System Requirements
The tables below list the minimum system specifications for your computer to be able to use Dante
Controller.
Disclaimer: It is possible that your computer may meet the requirements below, but suffer from some
other individual performance limitation related to its particular hardware. Please seek the advice of your
computer support administrator.
General
Component Recommended Minimum Requirement
Processor 1GHz or better
Memory 512Mbyte of RAM