User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Setup workflow
MRX Setup Manual
6
Follow the steps below to install MTX-MRX Editor.
1.
After decompressing the downloaded file, double-click “setup.exe” in the decompressed
file location.
The MTX-MRX Editor setup wizard will appear.
2.
Proceed with the installation as directed by the instructions in the screen.
Starting up MTX-MRX Editor
Follow the steps below to start up MTX-MRX Editor.
1.
Double-click the MTX-MRX Editor icon on the desktop.
2.
If the “Network Setup” dialog box appears, click [OK] or [Cancel].
You’ll be performing the setup during the step “Specifying the computer’s TCP/IP address”
3.
The “Startup” dialog box will appear; click [New file] and then click [OK].
The “Device Configuration Wizard” will start up. Now you can proceed to make basic settings.
We will use specific examples to explain “Using the Device Configuration Wizard to create your device setup” and subse-
quent steps.
NOTE
If the computer you’re using does not have Bonjour installed, a screen asking you to install Bonjour will appear during the installa-
tion.
If you are asked to install Bonjour, download Bonjour from the Yamaha Pro Audio website, and install it. Then install MTX-MRX Edi-
tor again.
http://www.yamahaproaudio.com/
NOTE
The “User Account Control” dialog box may appear. Click [Continue] or [Yes].