User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Basic MTX3 system example (analog connections)
- Example 2) High audio quality system with XMV and YDIF connections (digital connections)
- Example 3) Using cascade mode to add MTX input channels (analog connection)
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Setting the MCP1’s UNIT ID
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 4) A system using Dante
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Dante settings between systems
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 5) A system using the PGM1 for paging
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Power-on the PoE-equipped gigabit network switch
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
MTX Setup Manual 154
Q:
If YDIF connections are in a ring, does the order of connections matter?
A:
The order is very important. If you ignore the order, it will not be possible to correctly specify the YDIF routing. Make
connections according to the “Configuration Diagram” displayed in [File] menu → [Print Configuration Diagram].
Q:
How should I make connections when daisy-chaining the Dante network connections in example 4?
A:
Make connections as follows.
Do not route the connection from the System B network switch to the System B XMV4280-D via the System A net-
work switch. This will cause the Dante network to loop within System B, making communication impossible.
System A
Q&A
ON
ON
Network Switch
EXi8
ID=02
MTX5-D
ID=01
EXo8
ID=03
BGM Player
CD Player
Power Amp 1
Power Amp 2
Power Amp 3
Power Amp 4
Room A
Room B
Main
Microphone
to the System B Network Switch for Primary
to the System B XMV4280-D