User Manual

“Input Source/Redundant” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
233
❑ “Input Source/Redundant” dialog box
Here you can specify for each channel whether the input source to the XMV will be digital or
analog. If the input source is specified as digital, you can specify that the input source will switch
from digital to analog when a pilot tone or analog input is detected. Here we explain the screen for
when the digital input is YDIF.
● [Redundant Mode] list box
Selects the redundancy method.
•[Off]
Redundancy is not used.
•[Backup]
Switch to analog input when the pilot tone of the digital input is interrupted due to
a broken connection or other problem.
•[Override]
Switch the digital input to the prescribed analog input when analog audio is
detected.
● [Auto Return] check box
If this check box is selected, operation will be as follows.
•In the case of Backup mode
When the digital input returns, the input source is switched to digital.
• In the case of Override mode
When the analog input falls below the threshold value, the input source is returned
from analog to digital.