User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
247
Select the following parameter types to be operated by the switches, and then make
various settings.
•Input Ch Send On
•Input Ch Send Level
❍ [DEVICE]
Select the device that you want to change. These are shown in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
In the [PARAMETER1] column, select the target ZONE.
In the case of Input Ch Send On, click the ? located at the left in [PARAMETER2],
to specify the channel’s state as ON/OFF/IGNORE. OFF can be specified only for
one channel.
In the case of Input Ch Send Level, set the following parameters as well.
❍ [Parameter Range]
✦[Upper Limit]
Specifies the maximum level achieved by pressing the switch.
✦[Lower Limit]
Specifies the minimum level achieved when you press the switch.
✦[Mute Enable] check box
If this check box is selected, the Mute state (–∞ dB) will be enabled if the level falls
below the value specified by [Lower Limit].
❍ [Switch]
Allows you to make switch-related settings.
[Sensitivity] specifies the sensitivity at which the parameter will change when the
switch is touched.