User Manual
Table Of Contents
- Cover
- Introduction
- Example 1) One remote location, and four microphones in the meeting room
- Example 2) One remote location, and eight microphones in the meeting room
- Example 3) Four remote locations, and four mics in the meeting room
- Example 4) Dividing between two meeting rooms and conferencing with separate locations
- Appendix
MTX5-D/MY4-AEC System Setup Manual 7
Here we explain the main points when adjusting the example setup shown below.
In this example, the signal flow is as follows.
NE: Near-end Mic
FromFE: From Far-end
NEVoice: Near-end Voice
FEVoice: Far-end Voice
TO FE: To Far-end
NR: Noise Reduction
Example 1) One remote location, and four microphones in the
meeting room
Microphone 1
Microphone 2
Microphone 3
Microphone 4
Network
Analog IN/OUT
YDIF
Analog IN
Analog OUT
MTX5-D
XMV4140
CODEC Remote A
Meeting room
NE
4 ch
1 ch 1 ch 1 ch 1 ch
FEVoice
1 ch
InputCh
9
Adjustable
parameter
Signal path with adjustable parameters
Signal path with non-adjustable parameters
Non-adjustable
parameter
4 ch
1 ch
4 ch
4 ch
1 ch
4 ch
Matrix 10 ZONE 10
OutputCh
6
NR = ON
Secondary FBS
NR = ON
Primary
FBS
To FE
NEVoice
FromFE
Direct
Input 17
1 ch
1 ch
Matrix 1InputCh
1–4
InputCh
5–8
Matrix 9
ZONE 1
ZONE 9
1 ch
1 ch 1 ch
1 ch
YDIF 1
OutputCh
1
OutputCh
5
CODEC
([OUTPUT] 1)
XMV
(A ch)
CODEC
([INPUT] 5)
Mic In
([INPUT] 1–4)
Input Matrix Zone Output AEC
Patched directly
to AEC