User Manual

Wireless DCP Owner’s Manual
41
8. Troubleshooting
 Emergency Notification
The MTX processor is set to Emergency Mode in the case of a
disaster.
 Failed Internet connection Possible cause
Attempting access to the Internet via the Wi-Fi access point (or
router).
Action
Make sure the Wi-Fi device is set properly, for example, with no
redirect setting.
Note that Internet connection is not required in order for Wireless
DCP to connect to an MTX processor.
For details on setting instructions, contact the device’s dealer.
 To disable automatic connection
• Step A : From the Controller screen
1. Tap Settings in Wireless DCP.
2. On the Settings screen, tap Select Device.
3. As described in
“To connect to a different device” (page 32),
select the MTX processor being controlled.
4. Automatic connection will be disabled when the Enter PIN
screen is displayed.
• Step B : Start-up
1. Tap Cancel when the Enter PIN screen is displayed.
2. Automatic connection will be disabled when the Select Device
screen is displayed.