User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
“LIMITER” parameter setting window
MRX Designer User Guide
110
“LIMITER” parameter setting window
Here you can make limiter settings for each output channel. The following explanation
uses the HIGH band window.
1 LIMITER [ON] button
Switches the limiter function between enabled and disabled.
2 Limiter curve
This shows the effect as a graph. The horizontal axis is the input signal level, and the
vertical axis is the output signal level.
3 [GR] meter
Indicates the amount of gain reduction.
4 [OUT] meter
Shows the output signal level.
5 [THRESHOLD] knob
Specifies the threshold level at which the limiter is applied.
6 [ATTACK] list box
Specifies the speed at which the limiter will take effect. If Manual is selected, a knob is
shown, allowing you to specify the setting in msec units. If Fast/Mid/Slow is selected,
the following settings will be made automatically according to the crossover’s HPF
cutoff frequency in the Speaker Processor settings.
• Fast............. 1/4 wavelength of the cutoff frequency
• Mid............. 1/2 wavelength of the cutoff frequency
• Slow............ 1 wavelength of the cutoff frequency
2 3
6
7
1
4
5