User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
If [FUNCTION] is [MRX Source Select] (MCP1)
MRX Designer User Guide
140
If [FUNCTION] is [MRX Source Select] (MCP1)
The function assigned to the switch will change according to the “Source Selector”
component specified beforehand in the “Source Select” tab of the “MCP1” dialog box.
If the source select function is assigned to a switch
Tap the switch to change sources.
Switch settings
Select the following parameter type to be operated by the switch, and then make various
settings.
•Source Select
❍ [PARAMETER1]/[PARAMETER2]
[PARAMETER1] shows the component that is specified in the “Source Select” tab.
[PARAMETER2] specifies the source that will be turned on. ON can be specified
only for one source.
Assigning the level adjustment function that is linked when the switch
selects a source
The linked level-type parameter will be operated when the switch is tapped to turn on the
source.
Switch settings
Select the following parameter type to be operated by the switch, and then make various
settings.
•Inc/Dec
❍ [PARAMETER1]/[PARAMETER2]
[PARAMETER1] shows the component that is specified in the “Source Select” tab.
[PARAMETER2] specifies the source that will be turned on. ON can be specified
only for one source.
❍ [Select Parameter:]
Specify the level-type parameter that will be linked with the selected source. The
[Clear] button clears the parameter.
❍ [Parameter Range]
Use [Upper Limit] and [Lower Limit] to specify the range in which the level can be
varied.
If [Mute Enable] is on, the Mute state (–∞ dB) will be enabled if the level is lowered
below the value specified by [Lower Limit].
By using [Parameter Range] you can limit the range in which the user can control the
volume.
For example you can use this to specify the maximum volume of background music,
or use a controller to make fine volume adjustments in a narrow range of –6 dB to
+6 dB.
❍ [Sensitivity]
This specifies the sensitivity at which the parameter will change when the switch is
tapped.
NOTE