User Manual
Table Of Contents
- Contents
- What you can do using ProVisionaire Touch
- Operating requirements of the software
- Terms and concepts to understand
- Installation procedure
- Startup
- Basic process
- Operations for common settings
- About the menu bar
- Settings file management — the File Management button
- Selecting multiple widgets — Multi Select button
- Creating a custom panel — the Page Edit button
- Widget design
- Assigning parameters
- Switching pages — the Page Selection button (Control mode)
- Managing pages — the Page Management button (Design mode)
- Registering devices to control — the Device Management button
- Control panel settings — the Setup button
- Control panel information — the Information button
- Preparations before you make connections
- Troubleshooting
- About the software license
66
Registering devices to control — the Device Management button
Here’s how to register a device of the target system that will be con-
trolled from the custom panel you created.
The device/parameter that’s controlled by a widget in the custom
panel is determined by the Model and Unit ID or IP address that you
register here.
1. You’ll use Design mode to register a device. If you’re
in Control mode, use the Operation Mode button to
switch to Design mode.
* If the menu bar is hidden, unhide it in either of the following ways.
• Touch the upper left of the screen, and authenticate using an adminis-
trator code.
• Close ProVisionaire Touch and then re-open it; then authenticate the
applicable file with an administrator code and reload it.
2. Tap the Device Management button .
3. Tap [Add Device].
Registering a device