User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-82-
The tab includes 3 sections:
n Avid Dante Card Information: Displays information about card hardware and software versions
n Avid Rack Status Information: Displays information about the rack status for the card
n Avid Dante Card Control: Allows the configuration of various DNT-192 settings
Avid Dante Card Information
This section displays:
Application version
The version of the Dante application currently installed on the DNT-192 card.
FPGA Version
The version of the FPGA binary on the card.
Board Version
The hardware version of the card.
Avid Rack Status Information
This section displays: