User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-90-
Important: When legacy devices are associated with a domain, they are not protected from
unauthorized access via Dante Controller. Also, when associated, they are placed in a dedicated
clock domain and thus can no longer exchange audio with unmanaged devices.
HiddenLegacy Devices
If a legacy device is moved to an unmanaged Dante network without first being de-associated, it will not
appear by default inDante Controller.
Dante Controller notifies you with a spy icon (next to the network status icons at the bottom left of the UI)if
you have hidden devices on your network:
To view hidden devices inDante Controller, select View > 'Show Hidden Devices'.
For more information about legacy devices, see the DDM user guide.
Domain Credentials
When a device is enrolled in a Dante domain, information about the relevant DDM server and the domain in
which it is enrolled is saved to the device. When the device is unenrolled, the domain membership
information is cleared, and the device returns to the unmanaged (unenrolled) domain.
If an enrolled device is moved out of the DDMnetwork to another network without first being unenrolled, it
will not appear in Dante Controller, because its domain credentials indicate that it is still enrolled in a
domain. In these circumstances it is necessary to clear its domain credentials so that it appears as an
unmanaged device in Dante Controller and can be used again.
To clear the domain credentials for a device, it must first be isolated using the same method for resetting a
device lock PIN.
1. Isolate the device.
2. Open the Device View for the device.
3. From the Device menu, select Clear Domain Credentials.