User Manual

Table Of Contents
Recorder
Reference Manual
191
When setup method selection button = SPECIFIED IP ADDRESS
If youre using DANTE-ACCEL, use the SPECIFIED IP ADDRESS field to specify the IP address of the
PC. Since the IP address of DANTE-ACCEL will differ from the IP address used by CL Extension, you
must specify the IP address manually.
This screen contains the following items.
1 IP ADDRESS knobs
Use the multifunction knobs to specify the IP address.
NOTE
As the IP address, specify the IP address of the PC that is running Nuendo Live.
Set the address of that PC in the range of 169.254.0.0 – 169.254.255.255, and set the subnet
mask as 255.255.0.0.
For the PC in which DANTE-ACCEL is installed, the Dante port of DANTE-ACCEL as well as the
Ethernet port of the PC must both be connected to the same network.
Refer to the illustration below.
NOTE
Depending on the firmware version, DANTE-ACCEL might not support redundant networking.
Refer to the following website to check whether your version of the DANTE-ACCEL (Dante
Accelerator) firmware supports redundant networking.
http://www.yamahaproaudio.com/
2. When you have finished making settings, press the OK button to close the
NUENDO LIVE SET UP popup window.
1
PC
SW
(Primary)
SW
(Secondary)
Ethernet
DANTE-ACCEL
P
S
CL
Dante
P
S