User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-66-
Note: Certain Ethernet switches support IGMP (Internet Group Management Protocol), a protocol
that provides the ability to 'prune' multicast traffic, so that it travels only to those end destinations that
require that traffic. If this is the case, and IGMP is correctly configured on all the Ethernet switches,
then multicast audio will not flood throughout the network, but will instead be sent only over the links
required to deliver it to subscribed devices.