User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-74-
8. In the 'Preset Roles' column, select the relevant role.
9. In the 'Target Devices' column, click Select All.
10. Click Apply then click OK.
This will set all devices to the same sample rate, but will leave all other device configuration settings
untouched.