User Manual

R Remote Version 3 User’s Guide 7
If the network consists only of Dante devices and R Remote, we recommend that you use the AUTO IP setting.
If you are connecting to an existing network, select DHCP as needed.
If you want to use zoning to set the IP address, or want to connect to an existing network but use a static IP
address, choose STATIC IP (MANUAL) and use R Remote to set the IP address.
・SECONDARY PORT
Settings Switch
DAISY CHAIN
(4 up)
REDUNDANT
(4 down)
・START UP MODE
Settings Switch
REFRESH
(The unit starts up with part of the internal memory
initialized.
Initialization creates the following settings.
・HA GAIN (-6 dB)
・+48V (OFF)
・HPF (OFF)
・HPF FREQ (80Hz)
・Gain Compensation (OFF))
(7 and 8 up)
RESUME
(The unit starts up using the settings assigned prior to the
most recent power off.)
(7 down, 8 up)
If a CL/QL series unit is not connected, we recommend that you set START UP MODE to RESUME. If this is set to
REFRESH, settings must be transmitted from R Remote each time the R series unit is restarted.
For RSio64-D
When using R Remote to operate an RSio64-D unit, set the DIP switches and [UNIT ID] rotary switch
of the unit, taking note of the following settings.
Set the DIP switches to the following setting.
・SECONDARY PORT
Settings
Switch
DAISY CHAIN
(4 up)