User Manual
Table Of Contents
- Contents
- What you can do using ProVisionaire Touch
- Operating requirements of the software
- Terms and concepts to understand
- Installation procedure
- Startup
- Basic process
- Operations for common settings
- About the menu bar
- Settings file management — the File Management button
- Selecting multiple widgets — Multi Select button
- Creating a custom panel — the Page Edit button
- Widget design
- Assigning parameters
- Switching pages — the Page Selection button (Control mode)
- Managing pages — the Page Management button (Design mode)
- Registering devices to control — the Device Management button
- Control panel settings — the Setup button
- Control panel information — the Information button
- Preparations before you make connections
- Troubleshooting
- About the software license
73
Example network settings for other than the iPad
1. Check the IP address setting (IP SETTING) of the
devices in the target system.
On the rear panel of the unit, make sure that DIP switch 6 is set to
UNIT ID (upward position).
The IP address will be specified by the UNIT ID, and will be
“192.168.0.(UNIT ID).”
2. On the computer that’s using MTX-MRX Editor, make
settings so that the IP address will be obtained auto-
matically (DHCP).
3. Change the IP address of the Wi-Fi access point.
Set the Wi-Fi access point to the same network (subnet) as the target
system. We recommend that you use “192.168.0.254” as the IP
address of the Wi-Fi access point. Connect the computer to the Wi-Fi
access point, and change it from the computer’s web browser. For
details on how to make this change, refer to the manual of the Wi-Fi
access point.
4. Set the router to automatically assign IP addresses
(DHCP).
Make sure that the IP addresses do not conflict with the devices of the
MTX/MRX system. The recommended range is “192.168.0.150” –
”192.168.0.200.” For details on how to make this change, refer to the
manual of the router built into the Wi-Fi access point.
5. Connect devices other than the MTX/MRX system to
the network.
6. Specify the IP addresses of devices other than the
MTX/MRX system.
When making settings in Windows, use the following method.
Make sure that the IP addresses do not conflict with the IP addresses
of other devices. The recommended range is “192.168.0.100”--
“192.168.0.149.”
For a Blu-ray disc player, connect it to a television etc., and in the
“SETUP” screen's [Network] section, set [IP Address] to [Manual]
and specify the IP address and subnet mask.
1 Hold down the <Windows> key and press the <E> key.
The Explorer opens.
2 In the left side of the Explorer, click “Network.”
The devices connected to the network are shown.
3 Double-click the icon of a device that is shown in the
“Media Devices” or “Other Devices” area.
The browser starts, letting you make settings for the device.
4 Specify the IP address.
• For a MusicCast device: In the network settings screen,
select “Wired” or “Wired LAN,” turn [DHCP] off, and spec-
ify the IP address and subnet mask.
• For a Disklavier: Go to [Settings] [Network] [Wired
Network] [Use DHCP] to specify manual settings,
specify the IP address and subnet mask, and click [Send].
[Send] might not be visible unless you scroll.
• For a CL/QL/TF/R series(AD/DA): Make settings on the
unit itself.