User Manual

Input channels
V2.0 Supplementary Manual
4
4. Select an output port or input port.
NOTE
• There is a limit to the sum of INSERT 1 and INSERT 2 for each channel group, as shown in the
table below. You can select any output or input ports.
• If you exceed the INSERT OUT or INSERT IN limitation, the indicator will light up on the left.
• If the limit is exceeded, invalid ports will be marked with a strike-out line.
• If the limit is exceeded, the following ports will take priority per channel group (listed in the table
above.)
1 INSERT 1 will take priority over INSERT 2.
2 Lower-number channel will take priority.
Input channels
Added gain function
If GC (Gain Compensation) is enabled, you can link the digital gain to the analog gain operation.
While you are controlling the analog gain, the Gain Compensation function enables you to modify the
level on your own console without affecting the level of other consoles.
■ Linking the gains
1. Press the GAIN knob in the GAIN/PATCH field in the OVERVIEW screen (or
SELECTED CHANNEL VIEW screen).
2. Press the 1ch tab or 8ch tab in the GAIN/PATCH popup window.
3. Press the AG➞DG LINK button to turn the link on.
Using the AG→DG ALL ON button and AG→DG ALL OFF button enables you to turn the link
between the analog and digital gain for all input channels simultaneously.
You can also view the link status in the SELECTED CHANNEL VIEW screen.
CH1-16 CH17-32 CH33-48
CH49-64
(CL5 and
CL3 only)
CH65-72
(CL5 only)
MIX1-24/
ST/MONO
MATRIX1-8
INSERT OUT 16 16 16 16 8 30 8
INSERT IN 16 16 16 16 8 30 8
AG➞DG ALL ON button/
AG➞DG ALL OFF button
AG➞DG ALL ON button/
AG➞DG ALL OFF button
AG➞DG LINK button
: Link is on.
: Link is off.