User Manual

CS-R5 Owner’s Manual
18
7 Strip encoder
You can use the Screen Encoder function and the
Channel Encoder function for channel strips 1–12.
Use the [ENCODER ASSIGN] key (see 1 on
page 17) to toggle between these two functions. You
can use only the Channel Encoder function for
channel strips A and B.
• Screen Encoder function:
Up to 12 parameters can be assigned by selecting
controls on the screen.
• Channel Encoder function:
Parameters for 12 channels on the channel strips
can be assigned. Use the [ENCODER ASSIGN]
key (see 1 on page 17) to toggle between these
two functions.
8 [SEL] key
Enables you to select the channel that will be
controlled in the Channel Strip section or on the
display. When the channel is selected, the key LED
will light.
9 [ON] key
Switches the channel on or off. If the channel is on,
the key LED will light. If the channel is in a mute
group, the key indicator will flash. In SENDS ON
FADER mode (see 6 [SENDS ON FADER] key on
page 17), this key works as an on/off switch for
signals sent from each channel to the currently-
selected MIX/MATRIX bus.
) Fader
This is a touch-sensitive 100 mm motorized fader. In
SENDS ON FADER mode, this fader adjusts the send
level of the signal sent from each channel to the
currently-selected MIX/MATRIX bus.
! [CUE] key
Selects the channel for cue.
@ Channel name display
Indicates the channel name, fader value, etc.
# Channel color indicator
Indicates the channel color.
$ Dynamics LEDs
Indicate the status of Dynamics 1 and 2.
% Meter LEDs
Indicate the channel level.
7
8
9
)
!
@
#
$
%