User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM10 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications (CS-R10, CS-R10-S)
- Index
RIVAGE PM10 System Setup Guide
19
EQUALIZER
1 EQUALIZER [1-4]/[(5-8)] keys
Switch the EQ bands for which you want to make
settings.
Pressing both [1-4] and [5-8] keys simultaneously
will set the gain for all bands to 0 (FLAT).
2 EQUALIZER [ON] key
Switches EQ on or off.
3 EQUALIZER [SHELF] key
Switches peaking filter to shelving filter.
4 EQUALIZER display
Indicates parameters for each EQ band.
5 EQUALIZER [Q] knob
Specifies the Q value.
6 EQUALIZER [FREQUENCY] knob
Sets the frequency.
7 EQUALIZER [GAIN] knob
Sets the gain.
LPF/HPF
1 LPF/HPF [FREQUENCY] knobs
Specify the cutoff frequency of LPF and HPF
respectively.
2 LPF/HPF display
Indicates the LPF and HPF settings.
3 LPF/HPF [ON] keys
Switch the LPF and HPF on or off respectively.
4 LPF/HPF [SLOPE] keys
Switch the LPF and HPF slope settings respectively.
DCA/MUTE/INSERT
1 DCA ASSIGN LEDs
Indicate the assigned DCAs.
2 MUTE GROUP ASSIGN LEDs
Indicate the assigned Mute Groups.
3 INSERT [PLUG-INS] key
Enables you to recall a parameter setting screen for
the inserted plug-ins.
4 INSERT 1/2 [ON] keys
Switch the INSERT1 and INSERT2 on or off
respectively.
1
5
6
3
2
7
4
2
3
4
1
1
2
34