User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM10 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications (CS-R10, CS-R10-S)
- Index
RIVAGE PM10 System Setup Guide
22
SCENE MEMORY section
1 [OVERLAY] key
Press this button to display the OVERLAY SETTING
screen.
While pressing and holding down the [SHIFT] key,
press the [OVERLAY] key to switch Overlay on or
off.
While Overlay is turned on, press and hold down the
[OVERLAY] key to enter Overlay edit mode.
2 [UNDO] key
Cancels the most recent scene operation of storing,
recalling or updating a scene.
After you cancel the operation by pressing the [UNDO]
key, you can “redo” the canceled operation by pressing
the [UNDO] key again.
NOTE
You cannot undo an operation to store a new scene.
3 [UPDATE] key
Updates scene data by overwriting the current scene
(that has been recalled most recently) with the
current mix data.
4 SCENE MEMORY display
Indicates the selected scene memory.
5 [PREVIEW] key
Switches Preview mode on or off.
6 [STORE] key
Stores the current scene settings to the selected scene
memory. If you select the existing scene, it will be
overwritten.
7 [INC]/[DEC] keys
Enable you to select the scene number of a scene that
you want to store or recall.
8 [RECALL] key
Enables you to recall a stored scene from scene
memory.
1
3
6
4
2
5
8
7