User Manual

RIVAGE PM10 System Setup Guide
29
Rear panel
CS-R10
CS-R10-S
1 LAMP jacks
These four 4-pin female XLR output connectors are
used to supply power to Yamaha LA1L gooseneck
lamps supplied with the unit.
(CS-R10: 4 jacks; CS-R10-S: 3 jacks)
2 MIDI OUT/IN jacks
These connectors are used to transmit and receive
MIDI messages to/from external MIDI devices.
3 GPI connector
This is a D-sub 25-pin female connector that allows
communication (8-in, 8-out) with a GPI-equipped
external device.
4 [FAN] switch
Sets the internal cooling fan to operate at either
HIGH or LOW speed.
NOTE
This switch is set to LOW when the unit is initially shipped
from the factory. As long as the unit is operated within the
specified ambient temperature range either the LOW or
HIGH setting can be used. The HIGH setting is
recommended if the ambient temperature is high, if the unit
is in direct sunlight even if the ambient temperature is
within the specified operating range, and in any situation in
which fan noise is not a problem.
5 VIDEO OUT connector
Connect your external display monitor to this DVI-D
(Dual-link) connector.
6 [RESET] switch
Resets the control surface.
Only the controls (screens, indicators, and control
keys and knobs) on the control surface will restart
without interrupting audio. Use this switch in case
the control surface becomes non-responsive to your
operations.
1
)
! #
@
( ( (
B
7
8
9
2 3 4 5 6
1 1 1
A
^
$
%
*
&
1
)
! #
@
( ( (
B
7
8
9
2 3 4 5 6
1 1
A
^
$
%
*
&