User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM10 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications (CS-R10, CS-R10-S)
- Index
RIVAGE PM10 System Setup Guide
41
10.
Press the Channel assign popup button.
For this example, select RY card slot 1.
11.
Press the APPLY button.
The setting will be applied to the output from the I/O
rack to the TWINLANe network.
12.
When a confirmation dialog appears, press
the OK button.
Patching the input ports
This section explains how to patch an input channel to the
input jack to which a microphone was connected in the
“Connecting the devices” section.
NOTE
The PATCH screen displays the input/output jacks assigned to
the TWINLANe network.
1. Press the PATCH button on the menu bar in
the touch screen.
The PATCH screen will appear.
2. Press the INPUT tab.
3. Use the knob in the upper-right corner to
display the desired input jacks.
NOTE
If you press an on-screen knob that you want to control,
you will be able to operate the knob via the [TOUCH AND
TURN] knob.
If you select RY card slot 1 on the I/O rack (M1),
“M1/RY SLOT1” will appear.
4. Use the knob in the lower left corner to
display the input channels.