User Manual
Table Of Contents
- 1. About the RIVAGE PM Network Setup Guide
- 2. Control Network Setup (RIVAGE PM Editor/RIVAGE PM StageMix/MonitorMix)
- 3. Dante Network Settings
- FAQ
- Q. Can two RIVAGE PM Editor apps be connected to one NETWORK [PC] connector?
- Q. When connecting multiple Dante networks with different physical connections to multiple HY144-D cards, can all the networks be set with their link-local address?
- Q. When connecting multiple Dante networks with different physical connections to multiple HY144-D cards, can all the networks be set with their link-local address?
- Q. The DANTE SETUP options in SYSTEM CONFIG are grayed out and cannot be edited. How can I make the settings?
- Q. Is it possible to segment a switch into a Dante network and a control network using a VLAN and connect the two networks to one switch?
24
When using a DHCP server to set an IP address, make sure that the IP addresses assigned
to the Dante device’s Primary/Secondary IP and SLOT IP are not in the same subnet as the
following IP addresses reserved for the RIVAGE PM system or the IP address of the DSP
ENGINE IP SETTING.
• 192.168.53.xxx /24
172.17.xxx.xxx /16 - 172.24.xxx.xxx/16
(These are reserved for RIVAGE PM systems.)
To use multiple HY144-D/-SRC cards, specify the Dante Control ID. Set a unique ID to each
card (except for ID OFF).
STATIC IP Setting
An IP address can be manually set for the Dante device on the IP and SLOT IP SETTING.
To connect two or more physically separate Dante networks, specify IP addresses in different
subnets (network addresses) to each network.