User Manual

Connecting Yamaha Dante devices with AES67
4
2. Execute “Clear Config” to initialize the Dante module for avoiding known issues.
3. Enable the AES67 mode.
Reboot will be needed if the AES67 mode was disabled.
Only devices that intend to transmit or receive AES67 flows need to have AES67 mode
enabled. It is also possible to communicate between AES67-enabled Dante devices
and standard (AES67-disabled) Dante devices at the same time.
4. Make sure the Tx Multicast Address Prefix (2nd octet) is set to 69 (default).
5. Create AES67 multicast transmission flows in Device View as usual, but tick “AES67
flow” first, before selecting which channels should be received by the non-Dante
AES67 devices.