User Manual

Connecting Yamaha Dante devices with AES67
5
Configuring the non-Dante devices
1. Make sure the non-Dante devices support SAP for automatic device discovery by
Dante Controller.
2. Configure them in AES67 mode, though the methods may be different for each device.
For details, please follow the instructions provided by each manufacturer.
Make sure to specify the same multicast network address prefix that you specified for
the Dante devices.
3. Create some AES67 multicast transmission flows (following the method described by
each manufacturer), which should be recognized by Dante Controller, and then patched
to the AES67-enabled Dante devices.
Making the patches to the Dante devices
1. Open the Routing tab on Dante Controller.
The non-Dante AES67 devices will appear in blue as the transmitters.