User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 7 Detail View window
Amp Editor Owner’s Manual
120
Attenuation section
Here you can monitor and control the amount of attenuation for each channel.
q Attenuator (TXn/Tn/PC-N/XMV only)
Use the slider or numerical entry to control the amount of attenuation for each channel. The GR meter (TXn
only) indicates the amount of gain reduction produced by the limiter of the amplifier protection circuit.
w [LINK] button (TXn/Tn/PC-N only)
This links the attenuator value between the channels. This button is unavailable in Bridge mode.
When clicking the [LINK] button to turn it on, use the pulldown menu to select how offset will occur between
the channels.
LINK on :
LINK off :
Absolute Link (Align to A) : The channel A value will be copied to channel B, and operation will be linked.
Absolute Link (Align to B) : The channel B value will be copied to channel A, and operation will be linked.
Relative Link : The offset between channels will be maintained, and operation will be linked.
q
w
re