User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 3 Setup
Amp Editor Owner’s Manual
21
7. Use an Ethernet cable to connect the [NETWORK] connector of the XMV to a network
switch, and then power-on all devices.
8. Verify that all connected devices are shown in the Tree View window.
• Make sure that all devices are displayed in the Tree View, then click the [Manual Mode] button.
In this way, the IP address assigned to the devices by the Auto IP Address Assignment function
will become static. This is a convenient way to assign a static IP address, especially if you want
to facilitate assignment of the IP address when the system starts up, or if you want to control
the devices using a remote controller, such as AMX/Crestron.
• Once the device IP address becomes static, uncheck the [Enable] checkbox in the Auto IP
Address Assignment section (page 92).
• It may take some time for IP addresses to be assigned to the devices. Correspondingly more
time will be required for a larger number of devices.
• If the network settings of a device are not the factory settings, it might not appear in the Tree
View window. In this case, operate the device’s front panel to change the IP Address Mode to
[DHCP], or initialize the device’s memory.
On the TXn unit, use [Utility] [Network Setup] to change the IP Address Mode to [DHCP],
and then press the unit’s front panel [ENTER] button.
On the ACD1 unit, use [6.Network Setup] [IP Address Mode] to change the IP Address
Mode to [DHCP]. For details on initializing the memory, refer to the owner’s manual or refer-
ence manual for each device.
NOTE