User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-64-
necessary.
To assign a static IP address:
1. Select 'manually configure an IPAddress' for the appropriate Ethernet port.
2. Enter the IPAddress and Netmask.
3. Click Apply.
The DNSServer and Gateway settings are optional - the device will use network defaults if they are not
specified.
Click Revert to revert back to the previous settings.
Note: Assigning static IPaddresses requires a device reboot.
HA Remote
For supported devices (Dante-MY16-AUD cards v3.3.9 and up), the Device View also includes an
HARemote tab. The HARemote tab allows the selection of the HARemote bridging mode for the device.