User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 8 Device Properties window
Amp Editor Owner’s Manual
143
r “Result”
Indicates the result of calibration and recommended threshold values.
• If even a single proper result is not obtained, this will be displayed in gray.
t [OK] button
Indicates the corresponding item’s value other than Detection Interval Time in the “Output Signal Check” tab,
based on the specified item, the measured level, and the impedance.
Detection Threshold : 3 dB lower than the detected level
Impedance Max : Double the detected impedance
Impedance Min : Half the detected impedance
NOTE