User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 5 Main panel window
Amp Editor Owner’s Manual
81
[LCD]
Contrast (TXn only)
Indicates/specifies the display contrast. The setting has a range of 0–100%.
Backlight (TXn/ACD1 only)
Indicates/specifies the lit status of the display’s backlight.
•ON
Always lit.
• If the power supply is in Standby mode, the operation will be the same as Auto OFF.
• Auto OFF
The backlight will light when a panel operation is performed, and will go dark ten seconds after the
panel operation has ended.
DIMMER (XMV only)
• Priority to Soft check box
Checking this check box will enable you to change the brightness of the LED on the rear panel from
Amp Editor. Unchecking this check box will disable the ON/OFF radio button, and you will be
unable to change the brightness of the LED on the rear panel from Amp Editor.
NOTE