User Manual

Assembly Guide
DTX400K/DTX430K/DTX450K Owner’s Manual
12
Attaching the third
tom part
1. Take the third tom part (e) from the package, and
using the tuning key, securely tighten the s key bolt.
2. Loosen the  key bolt.
3. Slide the third tom part (e) onto the right vertical sup-
port and lower it to the center of the support or there-
abouts. Ensure that the third tom pad is oriented as
shown in the above figure at this time.
4. Tighten the  key bolt to secure the third tom part (e)
in place.
Attaching the left
arm
1. Take the left arm (r) from the package, and using the
tuning key, securely tighten the s key bolt.
2. Loosen the  key bolt.
3. Slide the left arm (r) onto the left vertical support and
lower it to the center of the support or thereabouts.
Ensure that the left arm is oriented as shown in the
above figure at this time.
4. Tighten the  key bolt to secure the left arm (r) in
place.
Attaching the drum
module
1. Take the drum module (t) from the package and
loosen the
 key bolt.
2. Slide the drum module (t ) onto the left vertical sup-
port and lower it to a position about 10 cm from the top.
The angle at which the module should be assembled is
shown in the figure.
3. Tighten the  key bolt to secure the drum module (t)
in place.
IMPORTANT
The third tom part (e) and the snare part (i) from the
DTX400K are almost identical in appearance, and special
care should be taken to avoid mixing them up during the
assembly process. To tell them apart, look for the wing
bolt, which is only found on part i. See the figure on
page 8 for more details.
Care should be taken to avoid assembling the third tom pad
upside-down or back-to-front.
CAUTION
After completing this step, lay the assembly down
safely to prevent it from falling over.
The third tom pad will be rotated into place in .
Step 3
e
Rear of third tom pad
Right vertical support
NOTE
NOTE
Step 12
The joint shown in the figure is not part of the DTX400K.
CAUTION
After completing this step, lay the assembly down
safely to prevent it from falling over.
CAUTION
After completing this step, lay the assembly down
safely to prevent it from falling over.
Step 4
r
Joint
Left vertical
support
Step 5
t
10 cm
Left vertical support