User Manual

Practicing in Training Mode

DTX400K/DTX430K/DTX450K Owner’s Manual

Measure Break

With Measure Break training, the metronome will be muted for certain measures in a sequence. For example, by setting the

measures during which you play fills to be muted in this way, you can check for any deviation in your timing when the metro-

nome returns. This will help you to play at a constant tempo throughout your performances. Please note that this type of train-

ing is not scored.

1. Press the [TRAINING] button to activate Training

Mode.

2. Press number button [3].

The [] button will flash, indicating that the drum

module is on standby to start training.

3. Press the [] button.

The metronome will start to play a sequence of four

measures in length.

4. If necessary, press the number buttons corresponding to

the measures in the sequence to toggle the metronome

on (fully-lit) or off (half-lit) for them.

• Each of the number buttons represents a measure in

the sequence.

• On the first beat of each measure, the corresponding

number button will flash.

5. Practice playing the pads along with the song.

6. To end training, press the [] button once again.

1 3,6

2 4

You can also change the number of measures in the metro-

nome sequence. To do so, press and hold the corresponding

number button ([2] to [10/0]) until the displayed sequence

length changes. For example, to set the sequence length to

eight measures, press and hold number button [8].

Flash: First beat of measure currently being played.

Fully-lit: Measures for

which the metro-

nome is played.

Half-lit: Measures for which the

metronome is not played.

NOTE