User Manual

Setting Parameters using Menu Mode
DTX400K/DTX430K/DTX450K Owner’s Manual
46
4-5. Kick Velocity
Using the following procedure, you can adjust the velocity
(or power) of kick sounds produced using the hi-hat control-
ler. In order for the Kick Velocity parameter to have an
effect, Double Bass Drum must be set to “On” for the cur-
rent kit (page 43).
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [4] to select the Hi-hat Settings
parameter group.
3. Press number button [5] to select the Kick Velocity
parameter.
4. Enter a new velocity using number buttons [1] to [10/0].
5-1. Pad Velocity Curve
Using the following procedure, you can select a velocity
curve for individual pads. A velocity curve determines how
the velocity (or power) of a sound is affected by how hard
you strike the pad.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [5] to select the Trigger Settings
parameter group.
3. Press number button [1] to select the Pad Velocity
Curve parameter.
4. Strike a pad to select it.
5. Enter a new velocity curve setting using number buttons
[1] to [10/0]. The available settings are as follows.
Steps:
MENU ([KIT] + [SONG])  [4]  [5]  Setting
This parameter only has an effect when you are
using the hi-hat controller that comes with the
DTX400K.
Setting
1 to 127
Setting
b Trigger Settings
Steps:
MENU ([KIT] + [SONG])  [5]  [1]  Setting
Setting
1 to 25
Setting
1
2
3
4
5
6
7
8
9
10
Velocity
Trigger input level
Velocity
Trigger input level