User Manual

Transferring Song, Audio & Kit Data
8 DTX502 Reference Manual
The following message will be displayed on the drum trigger module’s LCD screen.
5. Click Flash Memory at the left of the main window.
6. Select the files you wish to transfer and click the Move button.
You will be asked to confirm if you wish to proceed. Clicking the Cancel button in this window will end the process without trans-
ferring any files.
7. Click the OK button to start file transfer.
The following message will be displayed on the drum trigger module’s LCD screen while transferring files.
8. When files have been successfully transferred, they will be temporarily stored in Musicsoft Down-
loader and listed in the corresponding area in the top half of the main window.
NOTICE
Operations via the DTX502 control panel, input from the pads, and the Auto Power-Off function will be disabled while data is being
exchanged with a computer.
NOTICE
Do not disconnect the USB cable while files are being transferred. In addition, the DTX502 should not be operated at this time.
Failure to avoid these precautions can not only prevent transferred data from being saved correctly, but in certain cases, can also
lead to the entire DTX502 memory being deleted.
10
10
8,9
13