User Manual
Table Of Contents
- RIVAGE PM Series Firmware Update Guide
- Precautions Read this before installing!
- Index
- Updating the CS-R10, CS-R10-S, CSD-R7, CS-R5 and CS-R3 firmware
- Updating the DSP-R10/DSP-RX/DSP-RX-EX and RPio622/RPio222 firmware.
- Recovery of the CS-R10, CS-R10-S, CSD-R7, CS-R5 and CS-R3 (Console I/O)
RIVAGE PM Series Firmware Update Guide 3
NOTE Some models do not support older firmware versions. In that case, the “Firmware found:” part
will be in red. The update cannot be executed.
6 Press the “Update” button.
A confirmation message is displayed prompting you to continue the update or not.
NOTE If both of the power connectors were not connected to the AC inlets at Step 3, the following message appears. Press the
“CLOSE” button, connect both power connectors to the AC inlets, and then update the firmware.
7 Press the “OK” button.
After starting the update, the update status is shown via the progress bar.
Do not turn the power off to the console during updating.
8 When the pop-up window indicating completion of the update appears, press the “SHUTDOWN” button.
9 After closing the pop-up window so that only the POWER LED is lit, reboot the console.
The firmware update is now complete.