User Manual
Table Of Contents
- RIVAGE PM Series Firmware Update Guide
- Precautions Read this before installing!
- Index
- Updating the CS-R10, CS-R10-S, CSD-R7, CS-R5 and CS-R3 firmware
- Updating the DSP-R10/DSP-RX/DSP-RX-EX and RPio622/RPio222 firmware.
- Recovery of the CS-R10, CS-R10-S, CSD-R7, CS-R5 and CS-R3 (Console I/O)
RIVAGE PM Series Firmware Update Guide 5
Others Ethernet (1000BASE-T/100BASE-TX)port
NOTE The System Requirements described above are applied to the RIVAGE PM FIRMWARE UPDATER V 3.0.0. You can check
the latest version information of each program and its system requirements at the following website.
https://www.yamahaproaudio.com/
The system requirements may differ slightly depending on the particular computer.
Use of an Ethernet cable (CAT5e or better) is recommended.
Connecting the computer to the device
Updating devices individually
Connect your computer directly to the DSP-R10/DSP-RX/DSP-RX-EX or the RPio622/RPio222 to update.
NOTE When an HY-144-D, HY144-D-SRC card is installed in the HY SLOT1 of the DSP-R10, DSP-RX or DSP-RX-EX,
updating from the Main I / O Network or Sub I / O Network is not possible. Connect to an appropriate terminal on the
external control computer and update the DSP-R10, DSP-RX or DSP-RX-EX individually from the Console Network.