User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM10 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications (CS-R10, CS-R10-S)
- Index
RIVAGE PM10 System Setup Guide
42
5. Press the desired grid cell to patch a desired
channel.
For this example, press the grid cell on which the
input jack (M1/RY SLOT1/1) intersects with input
channel (CH 1).
Patching the output ports
This section explains how to patch output channels to the
output jacks to which the speaker system has been
connected in the “Connecting the devices” section.
NOTE
The PATCH screen displays the input/output jacks assigned to
the TWINLANe network.
1. Press the PATCH button on the menu bar in
the touch screen.
The PATCH screen will appear.
2. Press the OUTPUT tab.
3. Use the knob in the upper-right corner to
display the desired output jacks.
NOTE
If you press an on-screen knob that you want to control,
you will be able to operate the knob via the [TOUCH AND
TURN] knob.
If you select RY card slot 2 on the I/O rack (M1),
“M1/RY SLOT2” will appear.
4. Use the knob in the lower-left corner to
display the output channels.